Parameter Setting - Ebyte E34-2G4H20D Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.

6. Parameter setting

Step Operation
Install Driver
1
Pull
2
jumper
Connect
3
module
Open
4
port
Interface
5
Input parameter
6
Complete the o
7
peration
Commands
8
Configuration
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co., Ltd.
Please install the USB adapter driver (CP2102).
out the
Pull the M0, M1 jumper out, 3.3V or 5V are available for jumper.
Connect the module with USB adapter.
to
Connect to the USB interface of PC.
Operate the parameter setting software, choose corresponding serial number and
serial
press the "OpenPort" button.
Please choose other serial numbers until open successfully.
Press"Preset"button，the interface will be as below.
If failed, please check if the module is in mode 3, or if the driver has been
installed.
Please adjust the parameter as your request according to the corresponding
setting, then click "SetParam" button, write the new parameter to the module.
Please operate the "Fifth step" if you need to reconfigure,
if the configuration is completed,
please click "ClosePort" and then take off the module.
Parameter configuration is also available for MCU (in mode 3).
Description
E34-2G4H20D User Manual
19