Advertisement
Non-Contact Thermometer- Quick Start Guide
NOTES for using this thermometer
•
Always make sure the thermometer is in BODY mode before taking a
measurement. The light next to the word BODY should be lit to indicate it is
in BODY MODE. If the light next to the word SURFACE is lit, press the
"MODE" button to select BODY MODE.
•
Store the thermometer in the room where you take your measurements. If
you move the thermometer to a new room to take a measurement and
the temperature in the new room is very different from where the
thermometer was stored, the reading may not be accurate. Bring the
patient to the thermometer, don't bring the thermometer to the patient.
Installing the Batteries
New batteries were installed in your device before shipping. Unless instructed by
a support person, skip this section
This product uses 2 AA batteries. Remove the battery cover
and place the batteries according to the polarity diagram
in the battery compartment.
V1.1
Wireless Non-contact Infrared
Body / Surface Thermometer
Quick Start Guide
Model # ADF-B38A
REMOTE CARE PARTNERS
PAGE 1
Advertisement
Table of Contents
Related Manuals for RCP ADF-B38A
Summary of Contents for RCP ADF-B38A
- Page 1 Non-Contact Thermometer- Quick Start Guide Wireless Non-contact Infrared Body / Surface Thermometer Quick Start Guide Model # ADF-B38A NOTES for using this thermometer • Always make sure the thermometer is in BODY mode before taking a measurement. The light next to the word BODY should be lit to indicate it is in BODY MODE.
- Page 2 The temperature displays in the LCD Viewing window. 5. The thermometer will turn off automatically in 1 minute. 6. The reading will automatically be transferred to the RCP SmartHub and then sent to your provider. Understanding the Results Your temperature will display on the LCD screen on the back side of the head of the thermometer.
Need help?
Do you have a question about the ADF-B38A and is the answer not in the manual?
Questions and answers