Page 1
Or visit our web site 24 hours a day, 7 days a week for product assistance at www.whalenstyle.com Or e-mail your request to parts@whalenfurniture.com THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE. Whalen Furniture Manufacturing Page 1 Factory: 10944 Date 2014-09-22 Rev. 1 Factory: FOCIDI...
Page 2
Stock # XLSFEC54-WN M A X I M U M R E C O M M E N D E D W E I G H T L O A D S MANUFACTURER: Whalen Furniture Manufacturing CATALOG: Santa Fe 3-in-1...
Page 3
Stock # XLSFEC54-WN Parts and Hardware List Please read completely through the instructions and verify that all listed parts and hardware are present before beginning assembly. A- Top Shelf with Metal Frame (1) B- Middle Shelf with Metal Frame (1)
Page 4
Stock # XLSFEC54-WN Parts and Hardware List Please read completely through the instructions and verify that all listed parts and hardware are present before beginning assembly. (7) 2-1/2” Lag Bolt (4) (8) Large Flat Washer (4+1 extra) (9) Concrete Anchor (4)
Page 5
Stock # XLSFEC54-WN Assembly Instructions A/B/C Flat Washer Large Floor Leveler 1-1/4” Bolt Lock Washer (12 used in this step) (1 used in this step) (12 used in this step) (12 used in this step) ⑥ ⑩ ⑤ ③ NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back and fully tighten all bolts.
Page 6
Stock # XLSFEC54-WN Assembly Instructions Flat Washer Lock Washer 5/8” Bolt (8 used in this step) (8 used in this step) (8 used in this step) ② ⑤ ⑥ 4. Stand the unit upright. 5. Fasten 2 Metal Brackets (J) to connect the Top Shelf Metal Frame (A) with both Side Frames (E and F), using four 5/8”...
Page 7
Stock # XLSFEC54-WN Assembly Instructions for Table-top Console Acrylic Stopper (1 used in this step) ⑪ NOTE: You must install the Acrylic TV Stopper to prevent TV from tipping when placing your flat panel television directly on the table-top console. If you plan to mount the TV to the wall, proceed directly to next page.
Page 8
Stock # XLSFEC54-WN Assembly Instructions for Table-top Console Tools required: Allen wrench (provided), Phillips screwdriver, Mallet, Power Drill, and 3/8” Drill Bit. 8. Position the assembled console at the desired location against a wall. If necessary, adjust the installed Large Floor Leveler (10) and the pre-attached Small Floor Levelers at the bottom of Side Frames (E and F) to level the unit.
Page 9
Stock # XLSFEC54-WN Assembly Instructions for Floating Swivel Mount 2-1/4” Bolt Flat Washer Lock Washer (6 used in this step) (6 used in this step) (6 used in this step) ⑥ ⑤ ④ 10. Align and attach the Spine (D) to the back of the console with six 2-1/4” Bolts (4) and six Washers (5 and 6).
Page 10
Stock # XLSFEC54-WN Assembly Instructions for Floating Swivel Mount Flat Washer Lock Washer 5/8” Bolt (6 used in this step) (6 used in this step) (6 used in this step) ⑤ ⑥ ② 11. Fasten the Swiveling Bracket (G) to the top of the Spine (D) with six 5/8” Bolts (2) and six Washers (5 and 6) by the enclosed M4 Allen Wrench.
Page 11
Stock # XLSFEC54-WN Assembly Instructions for Floating Swivel Mount BACK Flat Washer 1/2” Bolt Lock Washer (4 used in this step) (4 used in this step) (4 used in this step) ① ⑥ ⑤ 12. Hold and attach the flat side of the Mounting Frame (H) to the Swiveling Bracket (G) using four 1/2”...
Page 12
Stock # XLSFEC54-WN Mounting the Monitor Brackets to a television with a Flat Back NOTE: For televisions with a curved or recessed back, proceed directly to next page. 13. Determine the correct diameter of the Bolt the TV requires by hand threading them into the threaded insert on the back of the TV.
Page 13
Stock # XLSFEC54-WN Mounting the Monitor Brackets to a television with a Curved/Recess Back 15. Determine the correct diameter of the Bolt the TV requires by hand threading them into the threaded insert on the back of the TV. If you encounter any resistance, stop immediately. If you are unable to find the correct Bolt consult a local hardware store.
Page 14
Stock # XLSFEC54-WN Assembly Instructions for Floating Swivel Mount IL/IR IL/IR MAKE SURE ALL BOLTS ARE TIGHT AND THE SPINE IS AT A 90 DEGREE ANGLE. USE A QUALITY LEVEL TO VERIFY THE MOUNTING FRAME IS LEVEL PRIOR TO INSTALLATION OF TV.
Page 15
Stock # XLSFEC54-WN Assembly Instructions for Floating Swivel Mount 19. The Monitor Brackets (IL/IR) can tilt up to 11˚ downward and 5˚ upward, depending on your optimum viewing position. Keep the enclosed 3/16”Allen Wrench to ensure the Tilt Adjustment Knobs remain tightly fastened.
Page 16
Stock # XLSFEC54-WN Assembly Instructions for Floating Swivel Mount 5/8” Bolt (6 used in this step) ② 20. Attach 3 Cable Wheels (K) onto the backside of the Spine (D) with the 5/8” Bolts (2). NOTE: You can use the Cable Wheels to help keep the entertainment center’s cables and cords organized.
Page 17
Stock # XLSFEC54-WN Assembly Instructions for Floating Swivel Mount 21. Position the assembled console at the desired location against a wall. If necessary, adjust the installed Large Floor Leveler (10) and the pre-attached Small Floor Levelers at the bottom of both Side Frames (E and F) to level the unit.
Page 18
Stock # XLSFEC54-WN The following steps are only for those who wish to mount their TV directly to the wall. If you have already mounted your TV to the Swinging Floater or plan to display your TV on the top surface of the Console, disregard the following steps.
Page 19
Stock # XLSFEC54-WN Assembly Instruction for installing the Mounting Frame onto BRICK, SOLID CONCRETE OR CONCRETE BLOCK WALLS 2.50" (63 mm) Maximum weight 135 lb. (61.2 kg) Concrete Anchors should only be used for masonry mounting. NEVER use the wall anchors to mount the unit to drywall.
Page 20
Stock # XLSFEC54-WN Assembly Instructions 29. Attach the Monitor Brackets (IL/IR) to the back of the television following steps 13 & 14, or 15 & 16, depending on the type of TV that you own. 30. Ask for assistance to lift the television up to attach the Monitor Brackets onto the Mounting Frame (H).
Should this product be defective in workmanship or materials or fail under normal use, we will repair or replace it for up to one (1) year from date of purchase. Every Whalen Furniture product is designed to meet your highest expectations. We guarantee that you will immediately see the value of our fine furniture.
Need help?
Do you have a question about the XLSFEC54-WN and is the answer not in the manual?
Questions and answers