Page 1
User’s Guide ake sure to read the before using the product. Keep the User's Guide(CD) in an accessible place for furture reference. ee the label attached on the back cover and quote this information to your dealer when you require service.
Page 2
On Safety Use only the power cord supplied with the unit. In case you use another power cord, make sure that it is certified by the applicable national standards if not being provided by the supplier. If the power cable is faulty in any way, please contact the manufacturer or the nearest authorized repair service provider for a replacement.
Important Precautions On Installation Do not allow anything to rest upon or roll over the power cord, and do not place the display where the power cord is subject to damage. Do not use this display near water such as near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool.
Positioning your display Remove the tape. Adjust the position of the panel in various ways for maximum comfort. -20˚~140˚ 140˚ -20˚ maximum 2.41inch (61.3mm) You can rotate the panel 90 clockwise. (* For detailed information, please refer to the Pivot Sofeware CD provided.)
Connecting the Display Using the Computer Connect the signal cable. When attached, tighten the thumbscrews to secure the connection. Connect the power cord into a proper power outlet that is easily accessible and close to the display. NOTE This is a simplified representation of the rear view. This rear view represents a general model;...
Page 6
2) Insert the Hantouch touch screen driver installation CD. 3) Open the [My Computer] -> [LG Driver] -> [Drivers] folder, then select the driver appropriate for your OS. 4) For more information, see the installation manual in the touch screen software installation CD bundled with the product.
Page 7
Your purchased product and its accessories may look different from the items illustrated in this manual.
Control Panel Functions Control SET/AUTO Button Power Button Power Indicator Function Use this button to enter a selection in the On Screen Display. AUTO IMAGE ADJUSTMENT When adjusting your display settings, always press the SET/AUTO button before entering the On Screen Display(OSD).
Screen Adjustment Allow the display to stabilize for at least 30 minutes before making image adjustments. To make adjustments in the On Screen Display, follow these steps: Press the MENU Button, then the main menu of the OSD appears. To access a control, use the becomes highlighted, press the SET/AUTO Button.
Page 11
The order of icons may differ depending on the model (A10~A14).
Page 12
OSD (On Screen Display) menu languages on the monitor may differ from the manual.
On Screen Display(OSD) Selection and Adjustment The OSD screen will appear when you press the front of the monitor. Menu Name Icons Sub-menu Name FLATRON F-ENGINE When you execute F-ENGINE, two tone will appear on the screen as shown in the picture. The applied screen will appear on the left side, whereas the non- applied screen will appear on the right side.Press the SET button to use the adjusted screen.