Table of Contents
Advertisement
4
CONNECTING TO THE MACINTOSH
COMPUTER
1. Turn off the computer and monitor.
2. Attach the Macintosh cable adapter to the Macintosh
video card.
3. Tighten the screws on the cable adapter.
4. Connect the signal cable provided with your monitor to
the other end of the Macintosh cable adapter.
5. Tighten the screws between the Macintosh cable
adapter and the signal cable.
Macintosh Adapter
(Optional Accessory)
Signal Cable
POWER MANAGEMENT SYSTEM
If you use the monitor with a computer that complies
with the power-saving program, you can set the monitor
to go blank when the system has remained unused for a
period of time. To specify the period or to disable this
feature, set the system timeout field of the computer's
system setup program or use special software for power-
saving. See the computer user's manual for the details of
using the system setup. While the monitor is in power-
saving mode (blank screen), it consumes less power than
when it is in its normal state. The color of the power
LED will indicate the state. To restore the screen image,
press any key of your keyboard or move your mouse. If
the signal cable is connected loosely or disconnected, the
power-saving feature will not operate.
DISPLAY DATA CHANNEL FOR PLUG AND
PLAY
If you use the monitor with a computer that complies
+
with DDC1/2B/CI/2B
of VESA, the host video card
automatically configures itself without your intervention
in a way that best fits the attached monitor. The Display
Data Channel(DDC) allows the monitor to inform the
host system about configuration information for optimum
use of the monitor. Use of the video card utility is not
required to match the resolutions and refresh rates of the
monitor and video card.
5
Advertisement
Table of Contents
