LESITE LST1600 Manual

LST1600/3400/2000
Please read this manual carefully before using this machine,
and keep it for future reference
Each hot air gun must undergo a double test of 100% performance and safety
before leaving the factory. A variety of nozzles and models can meet different
heating applications, and deeply meet the needs of customers.

Application

The following are different applications of hot air gun:
-Welding of roof polymer membrane and biutmem membrane
-Welding of tarpaulin and banner
- Processing of thermoplastic rigid materials in the manufacture of plastic containers
-Molding of thermoplastics
-Activation and shedding of adhesives and hot melt glue
-All kinds of drying and preheating processes

Precautions

Please confirm that the machine is turned off and unplugged
before disassembling the welding machine, so as not to be
injured by live wires or components inside the machine.
The welding machine generates high temperature and high
heat, which may cause fire or explosion when used incorrectly,
especially when it is close to combustible materials or explosive gas.
Please do not touch the air duct and nozzle(during welding work or
when the welding machine has not completely cooled down),
and do not face the nozzle to avoid burns.
The power supply voltage must match the rated voltage
marked on the welding machine and be reliably grounded. Connect
the welding machine to a socket with a protective ground conductor.
In order to ensure the safety of the operators and the reliable
operation of the equipment, the power supply at the construction site
must be equipped with a regulated power supply and a leakage protector.
The welding machine must be operated under the correct control of the
operator, otherwise it may cause combustion or explosion due to
high temperature
It is strictly forbidden to use the welding machine in water or muddy
ground, avoid soaking, rain or damp
-Welding of PVC floor
-Drying wet surfaces
EN