Advertisement
SETUP AND USE INSTRUCTIONS
1. This tree seat is designed to be used at a height that allows
the user's feet to be on the ground at all times when in use.
Use as a ground seat only.
2. Attach the long strap to either upper corner of backrest
frame. Wrap the loop end of strap around the backrest rim
and feed opposite end of strap through the loop. Pull tight
forming a cinch knot. This permanently attaches this strap to
the backrest rim. SEE FIGURE 2.
3. Repeat step 2 for strap with ratchet by attaching it to the op-
posite upper corner of backrest rim. Wrap the loop end of
strap around the backrest rim and feed the ratchet assembly
through the loop. Pull tight forming a cinch knot. This perma-
nently attaches this strap to the backrest rim. SEE FIGURE 3.
4. Standing on the ground, wrap long strap around tree and
feed the long strap through the center (slot) of ratcheting
mechanism and back around through tightening lever. SEE
FIGURE 4.
NOTE: Be sure you feed the long strap correctly so there are
no twists in the strap.
Pull tail of long strap until most of the slack is taken out. Be
sure entire strap is even and at the same level all around tree.
"Ratchet" tight to tree; this will securely attach the tree seat
to tree and prevent movement. SEE FIGURE 5. Make sure all
four (4) contact points of frames are touching tree (two on
tree hugger and two on backrest loop). Always test before
sitting on the seat.
NOTE: To release ratchet, simply pull the release lever and
open tightening lever wide open (flat).
5. Adjustment in height may be needed for comfort. Redo
set-up instructions as necessary to achieve a comfortable
seat height from the ground. Never attach this ground seat
at a height that will not allow you to have both feet on the
ground at all times during use.
6. Reverse setup and use instructions to take tree seat down.
Figure 2
Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
Rivers Edge® Lounger Tree Seat™
WARNING
DO NOT ALLOW EXCESSIVE STRAP BUILDUP IN
RATCHET AS THIS WILL PREVENT THE RATCHET TEETH
FROM ENGAGING CAUSING SLIPPAGE.
ALWAYS ATTACH RATCHET STRAP SECURELY WHILE
USING THIS PRODUCT!
NEVER STAND ON GROUND SEAT; IT IS DESIGNED FOR
SITTING ONLY.
Figure 3
Feed through slot
Release lever
Figure 4
Ratchet back
and forth
Figure 5
Operator's Manual
Tightening lever
Pull to take
out slack
TREE
5
Advertisement
