Advertisement
INSPECTION AND MAINTENANCE SCHEDULE
FOR ALL RIVERS EDGE PRODUCTS
• Inspect all webbing, rope, cord, and strap assemblies for wear or
damage.
• Inspect cables and cable ends for damage or kinking.
• Inspect all hardware and chain components for damage.
• Inspect for any structural damage to product. (Return to factory
for repair or discard product if any damage is found.)
• Inspect all nut and bolt assemblies to be certain none are loose.
• Inspect for any missing parts.
• Lubricate all pivot and slide together points with powder
graphite to prevent noise, wear, and rust.
• Inspect entire product for any rust, corrosion, cracks, freezing,
excessive heat, or rotting damage that may effect the safety of
your product. Discard any questionable product.
• Inspect entire product for any structural damage - pay close
attention to all weld locations. (Return to factory for repair or
discard product if any damage is found.)
• Using correct wrenches inspect all nut & bolt assembly locations
and snug up any that may be loose. Be careful not to crush tubing
when tightening!
• Inspect and check operation of all cables, cable ends, cord, rope,
webbing, and strap or chain assemblies. Replace with factory
new any item or assembly that shows signs of wear, damage,
kinking, or functions incorrectly.
• Inspect seat. Replace any seat with factory new that shows signs
of structural damage or wear.
• Inspect all hardware for wear or damage, also be sure you have
no missing parts.
• Never modify your stand in any way by making repairs, replacing
parts, or altering adding or attaching anything to it except if
explicitly authorized in writing by the manufacturer.
WARNING
PERFORM THESE TASKS BEFORE EACH AND EVERY
USE (REPLACE ANY QUESTIONABLE COMPONENTS
IMMEDIATELY
WITH
REPLACEMENT PARTS). DO NOT LEAVE YOUR GROUND
SEAT OUTDOORS – REMOVE AFTER EACH USE AND
STORE INDOORS!
INSTRUCTIONS SHOULD BE KEPT IN A SAFE PLACE
AND REVIEWED AT LEAST ANNUALLY.
REPLACE ANY AND ALL GROUND SEAT STRAPS EVERY
TWO YEARS OR WHEN ANY SIGNS OF DAMAGE OR
WEAR EXIST BEFORE.
NEVER USE ANY PRODUCT THAT HAS NOT BEEN
MAINTAINED OR INSPECTED PROPERLY – YOUR LIFE
DEPENDS ON IT!
4
RIVERS
EDGE
ORIGINAL
Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
Rivers Edge® Lounger Tree Seat™
ASSEMBLY INSTRUCTIONS
Tools needed – two 7/16" wrenches
1. Attach the tree hugger weldment (48078) to the seat frame
weldment using (1) provided 1/4-20 x 2-1/4" bolt, locknut and
metal washer. SEE FIGURE 1. TIGHTEN SECURELY.
2. Attach the backrest weldment (48075) to the seat frame
weldment (48081) using (2) provided 1/4-20 x 1-3/4" bolts
and locknuts. SEE FIGURE 1. TIGHTEN SECURELY!
NOTE: Pay special attention to orientation of both parts.
SEE FIGURE 1.
3. Attach the (2) provided 9" camo sleeves (48873) to each arm
rest portion of seat frame by wrapping around metal tubing
and attaching Velcro® of camo sleeves together with Velcro®
on seat straps.
4. Attach backrest portion of seat to the backrest weldment by
wrapping Velcro® loops around metal tubing and securing
together.
tree hugger weldment
seat loop weldment
2-1/4" bolt
#8-X 1/2 phillips
pan head screw
flat M4 washer
Figure 1
Operator's Manual
backrest weldment
1/4-20 lock nut
1/4 washer
1-3/4" bolt
Advertisement
