Table of Contents
Advertisement
Cable Entry
a) Drill a small pilot hole and then 10 mm hole in the back and de-burr the edges.
b) Push the power supply plug through the grommet
c)
Push the grommet into the hole using a flat blade screwdriver if necessary. Take care not to damage
the grommet. Insert the power plug in the socket on the PCB.
d) Push the audio cable through the grommet as well, pass it under the PCB and terminate as shown in
Diagram 2
Page 5 of 5
Approved Document No. DAU0001103 Rev 1
Advertisement
Table of Contents
Need help?
Do you have a question about the PDA103i and is the answer not in the manual?