Download Print this page

AndyMark Robot Competition Table Assembly Manual

Download this manual

AndyMark Robot Competition Table Assembly Guide

Included Parts & Hardware

4X - Flat Head Screw

8X - Dowel

1. Insert Dowels into Outer Panels

Locate the two Outer Panels and 8 Dowels. Using a mallet or Light Duty Hammer, gently insert dowels into

holes on the edge of each Outer Panel. Approximately half the dowel should protrude when fully inserted.

The inner panel does not recieve any dowels.

30X - Screw

22X - Spacer

30X - Washer

For more information visit AndyMark.com/Table

1X - Inner Panel

4X - Outer Section Wall

2X - Inner Section Wall

1X - East Wall

2X - Interconnect A

1X - West Wall

v1.0 10/7/20

Required Tools

Mallet

1/8" Allen Wrench

#2 Phillips Screwdriver

2X - Outer Panel

2X - Interconnect B

Need help?

Do you have a question about the Robot Competition Table and is the answer not in the manual?

Page 1 AndyMark Robot Competition Table Assembly Guide v1.0 10/7/20 Required Tools Mallet 1/8” Allen Wrench #2 Phillips Screwdriver Included Parts & Hardware 4X - Flat Head Screw 30X - Screw 8X - Dowel 22X - Spacer 30X - Washer 1X - Inner Panel...
Page 2 Using an 1/8” panel holes. Thread the screw into the threaded inserts in allen wrench, secure wall sections to the base panel. each side wall and leave loose until all the screws are installed. Spacer Washer Screw For more information visit AndyMark.com/Table...
Page 3 Inner Section Wall 3. Adjust the walls and ensure the outside edges of each wall are aligned with the edge of the base panel. Using an 1/8” allen wrench, secure wall sections to the base panel. For more information visit AndyMark.com/Table...
Page 4 Using an 1/8” panel holes. Thread the screw into the threaded insert and allen wrench, secure wall sections to the base panel. leave loose until all the screws are installed. Spacer Washer Screw For more information visit AndyMark.com/Table...