Saxby Lighting Pimlico Instruction Leaflet

Commissioning

• Fit the frame onto the base with the bayonet lock
and fit the glass pieces into their slots. Fit the bulb
NOTE: Never fit bulbs of a higher wattage than
those specified on the label (as these may cause
overheating and damage the fitting).

Fitting/replacing bulb

When changing a bulb, always switch off at the mains and
allow the bulb to cool before handling. Dispose of used
bulbs carefully.
Do not exceed the wattage stated or use a different shape
bulb from that indicated on the fitting.

Care and Cleaning

Do not use solvents or abrasive cleaners as these could
damage the finish. Rinse with clear water and with a soft
cloth, wipe dry.
Do not clean the units with a pressure washer.

Recycling advice

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.

Safety information

For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This bulb is protected by a shade. This part must be replaced immediately should the shade become
cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked Shade
www.saxbylighting.com
• Lock the decorative finial into the lantern cap using the
bayonet fitting, and clip the cap onto the frame. (Moulded
clips in the cap latch over the edge of the frame).
• Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
60W E27 GLS
Iss 2 11092015
Saxby Lighting Ltd. LS9 0SE
Instruction leaflet
Pimlico & Bayswater Post
EL-40043 and EL-40046