Operation - DDUUEETT sonia Maia Spray Manual

spray connection on the rear panel of the device
and to the spray tank, as shown in the diagram.
● Connect the handpiece vacuum to the vacuum
connection on the rear panel of the device and to
the vacuum handpiece, as shown in the diagram.
● Check the end of the vacuum handpiece to see
whether the sponge filter is installed; otherwise,
install it.
● Connect the appropriate vacuum head to the front
of the vacuum handpiece.
POWER AND CONFIGURATION
● Turn on the power switch on the rear of the
machine and press
The power indicator
will be in standby mode and ready for operation. On
the control panel:
- The timer will show 15 minutes.
- The power indicator will show 5.
- On the
will light up.
● Set the timer using the
choose the operating time of the machine, in a
range of between 1 and 30 minutes.
● Set the power using the
choose the power of the machine, in a range of
EN
4
on the control panel.
will light up. The machine
button, the pause indicator
or buttons to
or buttons to
between 1 and 9.
● Use the
button to start or stop the device.
- When running, the
- When paused or on standby, the
light up.

OPERATION

● Connect the device and leave it in standby mode
with the indicator lit.
● Select the operating time and power.
● Spray function:
- Hold the spray tank in your hand and press
. The run indicator
- Gently press the air outlet on the top of the tank
with your fingers to get the spray out the nozzle.
● Vacuum function:
- Firmly hold the vacuum handpiece in your
hands, place it in the desired position and press
. The run indicator
- The nozzle of the head should meet the skin.
- Lightly press the air outlet of the handpiece with
your fingers to make the vacuum of the skin in
contact with the head.
Bear in mind:
● The device should be put in pause mode
changing the vacuum tank or head.
● Prepare two spray tanks, for different liquids, and
you can alternate the tank according to your needs.
● Make sure that the sponge filter is installed on the
end of the handpiece before starting vacuum.
● Be careful when treating areas such as the mouth,
nose and eyes. The patient should keep their eyes
and mouth closed.
● The vacuum power should be kept under control, as
a high power could cause skin lesions.
● Test first on your own hand, and then start with the
patient once the vacuum power has been set.
indicator will light up.
indicator will
will light up.
will light up.
when