Advertisement
Advertisement
Table of Contents
Related Manuals for Edge DBX Series
Summary of Contents for Edge DBX Series
- Page 1 SERIES AMPLIFIER MANUAL EDA1200.1-E8 EDA1500.1-E8 EDA1800.1-E8...
- Page 2 Thank you for buying EDGE, we hope you enjoy listening to your product as much as we enjoyed creating it.
-
Page 3: Limited Warranty
EDGE. Graphics and logos are trademarks or trade dress of EDGE audio or its subsidiaries. EDGE’s trademarks and trade dress may not be used in connection with any product or service that is not EDGE’s, in any manner that is likely to cause confusion among cus- tomers or in any manner that disparages or discredits EDGE. -
Page 4: Mounting Guidelines
Mounting Guidelines Your EDGE amplifier is designed with a swift installation routine in mind. Please mount the amplifier in a dry location on a solid surface. NEVER mount the amplifier upside down as this will cause the amplifier to over heat and will eventually damage the amplifier. -
Page 5: Power Cable
Auto Turn On (High level Input Only) • The EDGE amplifiers feature an auto turn on circuit called Autosense. • This circuit allows the amplifier to switch on and off without a remote turn on wire when using high level input, for low level input (RCA) it will still be necessary to connect the remote turn on wire from the headunit. - Page 6 Terminals And Connections 1. High level input For connection to the speaker output of your source (head unit). This is to be used if the source (headunit) does not have a low level output. 2. Low level output RCA output used to connect an additional amplifier or audio device. 3.
- Page 7 Single Amplifier Configuration Minimum impedance 1Ω Minimum impedance 1Ω Minimum impedance 1Ω WARNING Driving multiple subwoofers at an impedance lower than that recommended by EDGE could cause damage to this amplifier that is not covered by warranty.
- Page 8 Amplifier Strapping Two Identical EDGE EDA monoblock amplifiers are capable of being strapped together to deliver the combined output of both amplifiers into a single channel. NOTE: only identical amplifiers may be strapped together. Strapping procedure · Connect the RCA input from the source unit to the left and right RCA input of the master amplifier.
-
Page 9: Set Up Section
Set Up Section To correctly set the gain control of the amplifier to match that of the source (headunit) use the following setup routine: Turn the gain control to minimum on the amplifier. Ensure the bass boost is set to 0 dB. On the headunit set all crossovers (if applicable) to flat and both bass and treble to zero. - Page 11 Дистанционное включение Заземление на кузов Предохранитель возле АКБ Battery...
- Page 12 • • • • • • • • • • • • •...
- Page 13 •...
- Page 14 • •...
- Page 16 • • • • • • • • •...
- Page 18 • • • • • •...
- Page 19 -11-...
- Page 20 SERIES www.edgecaraudio.com www.facebook.com/edgeaudio...
Need help?
Do you have a question about the DBX Series and is the answer not in the manual?
Questions and answers