Operating Instructions; Temperature Setting; Operating Procedure; Start-Up - H&K HCFRC30.01P Equipment Manual

High Capacity Propane Freezer/Refrigerator Combo

Operating Instructions

Temperature Setting

The combo has been tested and preset at the factory to maintain a temperature
between 33ºF (0°C) and 40ºF (4.4°C). The temperature controller located on the front
panel displays the internal temperature of the refrigerator.
To view current set point or if the temperature is not reading within the range specified
above, the electronic controller can be adjusted using the following procedure:
Info / Setpoint button
Manual defrost / Decrease button
Set point
Press button "i" key and hold for more than 1/2 second, to display set point value
By keeping button "i" pressed, use button  and  to set the desired value When
button "i" is released, the new value is stored.
A complete manual of the controller is attached with unit.

Operating Procedure

Start-Up:

The Combo is turned ON by plugging the cord into a Wall outlet. Turn Power switch on
back left of Refrigerator on. If Display on the front of the Refrigerator shows
Temperature the Refrigerator is on. If the Display shows OFF then press and hold the
On/Off button on the Display for 5 seconds. The evaporator fan will run immediately, the
compressor & the condenser fan will run after 1 minute delay. Let the unit run for 30
minutes before placing product in the Combo.
This manual is for the exclusive use of licensees and employees of McDonald's Systems Inc.
Controller
(Display and modification of desired temperature value)
Increase / Manual activation
button
Exit / Stand-by button
7 of 22
Revision E