WDM NE Series Operation Manual page 18

Operation Manual.
Carefully assemble the double seal bracket (3) onto the
motor (5) using motor screws. Then tighten the screws and
insert into the body housing (16). Secure the coupling with
nuts (13) and then add oil as specified above.
Double Seal
Bracket (3)
Electrical connections.
Check the cables to ensure there are no tears or defects. In case of
damage, replace the entire cable assembly cover (20). Remove the
motor cables through the top of the pump housing, check their
sleeves, and replace as necessary. Place the square ring (23) in the
conduit housing (20) reconnecting motor leads to power cables and
moisture and temperature sensors to control cables as shown in
Diagram 4.
18
Mechanical Seal (6)
Clamp
Seal Plate (2)
Diaphragm