Table of Contents
Advertisement
Quick Links
ICON – WRX
Contents
Product Description & Features
Wireless Detector Low Battery & Tamper Warning
Overview
Your MCM Electronics
Your MCM Electronics ICON-WRX
receiver, specifically designed to operate with certain MCM Electronics Security
receiver, specifically designed to operate with certain MCM Electronics Security
Alarm Control Panels.
Alarm Control Panels.
Main Features include:
Main Features include:
♦ Simple Installation - No EOLR required between receiver outputs & zone inputs – 10k
♦ 12 volt Dc operation.
♦ Code Hopping Remote Control Technology (remotes can not be copied by scanning or
code grabbing).
♦ Remote Functions include Arm, Disarm & Panic.
♦ Ability to quickly add or delete detectors from your system.
♦ 5 Wireless Detector Zones Available.
♦ Low Battery Warning Output
♦ Sensor Tamper Warning Output
♦ Intelligent "Sensor Learning" to prevent accidental code duplication.
♦ Wireless Detectors available include PIR's, Internal or External Reed Switches, Smoke
Sensors & Wireless Emergency Pendants.
– 8 Channel Radio Receiver
– 8 Channel Radio Receiver
Description
Description
ICON-WRX is a state of the art narrow band wireless
is a state of the art narrow band wireless
A.C.N 001 621 610
Page
Page
1
2
3
4
5
5
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MCM Electronics ICON-WRX
Summary of Contents for MCM Electronics ICON-WRX
- Page 1 Overview Your MCM Electronics Your MCM Electronics ICON-WRX ICON-WRX is a state of the art narrow band wireless is a state of the art narrow band wireless receiver, specifically designed to operate with certain MCM Electronics Security receiver, specifically designed to operate with certain MCM Electronics Security Alarm Control Panels.
- Page 2 Operation ARM/DISARM ARM/DISARM: Press the yellow button once for 1 second. PANIC: PANIC: Activate by pressing & holding down holding down the yellow button for at least 3 seconds. This sets off the siren. To cancel “panic”, press the yellow button once. The antenna wire provided is to be screwed into the terminal shown in the diagram above.
- Page 3 make sure Antenna is Antenna outside metalwork 10k resistors are inbuilt in receiver +12Volts 0 Volts Radio Sensor 1 (connect as required) Radio Sensor 2 (connect as required) Radio Sensor 3 (connect as required) Radio Sensor 4 (connect as required) Radio Sensor 5 (connect as required) Low Battery (connect if required)
- Page 4 To Add a Remote Control 1. 1. Set dipswitch Number 8 only only to the ON position. The yellow Program LED will come on. (If the Program LED flashes, check that, you don't have more than one dipswitch set to on). IMPORTANT When programming, make sure that no other...
- Page 5 To Add a Sensor Wireless PIR, Reed Switch, Smoke Sensor, or Emergency Buttons Select the Zone (1-5) that you wish to program a detector into. The yellow Program LED will come on. (If the LED flashes, check that, you don't have more than one dipswitch set to on).
- Page 6 To Default the Receiver (delete all sensors and Remotes) You can default your ICON - WRX in case you make a mistake, or are unsure of your receiver setup. "Defaulting" your receiver will cause all all detector & remote detector & remote codes to be erased codes to be erased.
Need help?
Do you have a question about the ICON-WRX and is the answer not in the manual?
Questions and answers