Advertisement
RedPlate RedLine Operations Guide
The RedLine comes complete with a footswitch:
MASTER – Light on = Master1 control is active, Light off = Master2 control is active.
1. Check the Standby switch to make sure it is toggled downward for Standby operation.
2. Toggle the main power switch to the up position (this switch is located at the top of the IEC
input module). The front panel pilot light should be lit.
3. Wait one minute and then toggle the Standby switch upwards to the Operate position.
4. POWER OFF – Toggle the main power switch downward, there is no need to go into
standby first although it will not hurt anything.
Your RedLine amp has been designed for years of trouble free operation. The vacuum tubes
will need to be replaced over time. We recommend new output tubes every 160 - 240 hours and
new preamp tubes every 320 - 480 hours.
The front and rear panels have a protective finish that can be easily scratched with abrasives
so always use a damp soft cloth to clean them (never use paper towels).
All tube brands are acceptable, a long plate is preferred in the V5 (Phase Inverter) position.
FOOTSWITCH
POWER ON/OFF PROCEDURE
MAINTENANCE SECTION
TUBE CHART
3
Advertisement
