SCS Sentinel kit HWay 24V Manual page 31

Blinker
press
24V DC
Coaxial
black wire
Fixing screw
Top view
If you want to improve the operating range of your
remote, you can connect the blinker antenna with a
RG58 coaxial cable (not supplied).
In this case you must disconnect the original antenna
and then connect the coaxial copper core to the
terminal ANT and the coaxial braided shield to the
terminal GND on both antenna and electronic card.
Coaxial cable
Braided shield
Copper core
Placed at the bottom right of PCB
press
EN
31