Check Procedure (Base Unit); Preparation; Pc Setting - Panasonic KX-TCA151AXM Service Manual

11 CHECK PROCEDURE (BASE UNIT)

11.1. Preparation

11.1.1. Equipment Required
• • • • DECT tester: Rohde & Schwarz, CMD 60 is recommended.
• • • • Frequency counter: it must be precise to be able to measure 1Hz (precision; ± 4ppm).
Hewlett Packard, 53131A is recommended.
• • • • DC power: it must be able to output at least 1A current under 9V.
• • • • Digital multi-meter (DMM): it must be able to measure voltage and current.
• • • • Oscilloscope
11.1.2. JIG and PC
• • • • EEPROM serial JIG
JIG Cable: PQZZ1CD505E
• • • • PC which runs in DOS mode
• • • • Batch file for setting: PQZZTCD530AX

11.2. PC Setting

11.2.1. Connections
11.2.2. PC Setting
1. Open a window of MS-DOS mode from the start-up menu.
2. Change a directory.
3. Type "SET_COM 1" from the keyboard (when COM port 1 is used for the connection).
4. Type "doskey".
Note:
See the table below for frequently used commands.
Command name
rdeeprom
readid
writeid
setfreq
hookoff
hookon
Getchk
Wreeprom
For Service Hint:
Please make sure the speed of COM port is "9,600 bps" or less.
Function
Read the data of EEPROM
Read ID (RFPI)
Write ID (RFPI)
adjust Frequency of RFIC
off-hook mode on Base
on-hook mode on Base
Read checksum
write eeprom
Example
Type "rdeeprom 00 00 FF", and the data from
address "00 00" to "FF" is read out.
Type "readid", and the registered ID is read out.
Type "writeid 00 18 E0 0E 98", and the ID "0018 E0 0E
98" is written.
Type "setfreq nn".
Type "sethooksw 01".
Type "sethooksw 00".
Type "getchk".
Type "wreeprom 01 23 45". "01 23" is address and "45"
is data to be written.
57
KX-TCD530AXM / KX-TCA151AXM