Lubrication Chart - Bolens 1053 Owners And Maintenance Manual

Proper lubrication and regular maintenance will in-
crease the operating life of your HUSKY tractor.
It is suggested that lubrication recommendations in
this manual be followed.
prepared by the operator would be beneficial.
LOCATION
1. Front Wheel Ball Bearings
2. Front Wheel Spindle
3. Front Axle Pivot
4. P.T.O Pulley
*5. Tie Rod Ends and Drag Links
6. Transmission
7. Air Cleaner
8. Engine Crankcase
9. Hood Hinge
*10. Brake Linkage
11. Starter
*12. Attachment Lift Lever
*13. Steering Shaft
14. Clutch
*More frequent if application demands. See your dealer for specified oil for complete refills.
Note: A hand type grease gun with a flexible hose is recommended when greasing your unit. This type
grease gun can be purchased at most automotive supply stores. Ask for Alemite All Purpose
Grease Gun part No. 4031 with Flexible Hose Assembly No. 6703A, or similar type. Hi-pressure type
grease guns could cause damage to the fittings and bearing seals. Lubricate all linkages, levers
and pins not equipped with grease fittings with an oil can once a week or oftener depending on
operating conditions. See separate Engine folder for amount and type of oil for various temperatures.
12
LUBRICATION
Figure 21
A lubrication schedule

LUBRICATION CHART

TYPE OF
LUBRICATION
Gun grease
Gun grease
Grease
Gun Grease
Oil
SAE-90
SEE ENGINE MANUFACTURER'S MANUAL
SEE ENGINE MANUFACTURER'S MANUAL
Oil
Oil
Oil
Gun grease
Oil
The numerically listed locations on the lubrication
chart correspond to those numbers shown on Figures
18, 19, 20 and 21.
AMOUNT OF
LUBRICATION
1 or 2 Strokes on gun
1 or 2 Strokes on gun
1 or 2 Strokes on gun
1 or 2 Strokes on gun
Coat bearing surface
Fill to plug level
Coat bearing surface
Coat bearing surface
NO LUBRICATION REQUIRED
Coat bearing surface
1 or 2 Strokes on gun
Coat bearing surface
sfh
FREQUENCY
OF LUBRICATION
8 hrs.
8 hrs.
8 hrs.
8 hrs.
8 hrs.
25 hrs.
25 hrs.
8 hrs.
8 hrs.
8 hrs.
8 hrs.