Advertisement
INSTALLATION
INSTALLING PVC SLEEVE CONNECTOR TO
GENERATOR POWER INLET bOX
1. Remove the power inlet box cover (A) Fig.8 by
removing the two front screws (B). Slide the
cover off by sliding it upwards.
2. Slide the NEMA plug assembly (A) Fig.9 out of
the power inlet box as shown.
3. Locate the round knock-out cover (B) Fig.9 and
push it out to remove it. Install the plastic
washer (C) in its place.
4. Locate the 1/2" PVC sleeve connector (D) Fig.9,
disassemble the locking ring (E) as shown.
5. Insert the 1/2" PVC sleeve connector (A) Fig.10
through the rear hole in the power inlet box,
secure the connector with the locking ring (B)
removed previously. Use pliers to properly
secure locking ring.
INSTALLING GENERATOR power inlet box TO
PVC CONDUIT
1. Install insulating gasket (A) Fig.11 over the rear
of the sleeve connector, as shown.
Note: Outside walls can come in different styles
and configurations, if the power inlet box doesn't fit
perfectly up against the wall, use the second
insulating gasket to increase waterproofing.
INSTALLATION
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
Advertisement
