Advertisement
Advertisement
Table of Contents
Related Manuals for ADENDORFF MAC AFRIC SMIXER-001
Summary of Contents for ADENDORFF MAC AFRIC SMIXER-001
- Page 2 GENERAL POWER TOOL SAFETY WARNINGS Use of an RCD reduces the risk of electric shock. protected supply. NOTE: The term “residual current device (RCD)” may be replaced by the term “ground fault (For All Power Tools) circuit interrupter (GFCI)” or “earth leakage circuit breaker (ELCB)”. Failure to follow all WARNING! Read and understand all instructions.
-
Page 3: Specifications
controlled with the switch is dangerous and must be repaired. SPECIFICATIONS 19. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Model SMIXER-001 Q1U-FF02-160B Such preventive safety measures reduce the risk of starting the power tool Rated Power Input 800 W... -
Page 4: Instructions For Operation
Stirring Operation INSTRUCTIONS FOR OPERATION When start stirring operation, put the stirring paddle into the material to be stirred firstly before Installing or Removing Stirring Paddle switching on the tool; And when stop operation, switch off the tool firstly and wait until the tool CAUTION: has come to a complete stop before pulling the stirring paddle out. - Page 5 Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark (Fig. 4). Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes.
- Page 6 EXPLANATION OF GENERAL VIEW Stirring Paddle and Stirrer Assembly Baffle Plate Drive Spindle Stator Assembly Flat Key Trigger Switch Bearing Retainer Left –half Handle Ball Bearing Pan Head Tapping Screw Gear Housing Cover Capacitor Needle Bearing Pan Head Tapping Screw Fiber Washer Right-half Handle Gear(Small)
Need help?
Do you have a question about the MAC AFRIC SMIXER-001 and is the answer not in the manual?
Questions and answers