Table of Contents
Advertisement
(g) Under no circumstances should a mat
sensor be cut or drilled. It is not possible for
the user to modify the size or shape of a mat
sensor.
(h) Great care should be taken when handling
mat sensors. Never pick the sensor up or drag
it around using the cables. Never bend a mat
at a radius less than 300mm. Keep mat sensors
flat whenever possible. Always store flat. Mat
sensors with one edge longer than 1 metre
should be handled by two people.
MACHINE
Figure 5 - Ensure operator is always standing on active area of sensor
(i) After installation the machine/mat system
must be commissioned in accordance with
section 5 of this manual.
(j) Any covers removed during installation
must be replaced as soon as possible.
SLOPING SKIRT FIXED TO MACHINE
MAT
OPERATOR ON TIPTOE ALWAYS
ON ACTIVE ZONE OF SENSOR
9
Advertisement
Table of Contents
