Page 1
Model Voltage Power Suitable for aquarium Lamp dimensions Light power LRW165-400H 24 V 60 W 40-50 cm 40x16,5x2 cm 6000 lumen LRW165-600H 24 V 90 W 60-70 cm 60x16,5x2 cm 9000 lumen LRW165-800H 24 V 120 W 80-90 cm 80x16,5x2 cm 12.000 lumen...
Table of content Safety instructions and usage of led lighting system Recycling Areas of application Special characteristics of led lighting system Installation steps Warranty card Warranty conditions Contact Safety instructions and usage of led lighting system Please adhere to the following: ●...
Page 3
and other liquids placed on the lighting can leak, which can cause damage to the anodized surface, and thus degrade the level of heat release and the aesthetics of the led lighting system it’self. Due to the heat, plant fertilizers and fish food deteriorating faster. ●...
Recycling This product must be disposed of in accordance with European regulations in order to reduce it’s impact on the environment. Contact your local or regional waste management representative for more information on how to dispose of them. Electronic products that are not included in the selective treatment of waste can be dangerous to the environment and human health.
Installation steps ● Unpack the led lighting system, check that it is not damaged or that all belonging accesories are complete (contact your dealer or manufacturer for any defects) ● Place the two stainless steel legs (7) in the holes on the side of the bracket and tighten them with the hand screws (6) below.
Page 6
● Remove the protective film from the plexiglass! ● Place the led lighting system with pre-assembled legs on the edges of the aquarium and adjust the legs so that they fit perfectly on both sides of the aquarium. ● Place power and mains connections in the aquarium cabinet, out of the reach of children. The power supply and connectors must not be placed in tight spaces or covered with anything to ensure proper ventilation.
Page 7
There is no need for an additional timer in addition to the controller, as the controller can control the brightness as well as the time intervals expressed in minutes. Further descriptions, guides and related programs can be accessed and downloaded from the official Lumen-aquatech website.
Page 8
● Connect the power cord to the AC power connector and make sure it is connected properly. ● Plug the timer into a wall outlet and set it to "OFF", then plug the led lighting system plug into the timer. If the led lighting system has a built-in controller, no special timer is required for led lighting system.
Warranty card Lumen led lighting systems has a full warranty of 24 months from the date of purchase. Save your invoice as proof of purchase. Complaints about led lighting systems that do not have an invoice will not be accepted.
Lumen Aquatech always strives to repair or replace the device within a maximum of 15 days. If the manufacturer does not perform the repair or replacement within the period corresponding to his...
Need help?
Do you have a question about the LRW165 H Series and is the answer not in the manual?
Questions and answers