Advertisement
Headboard
Sleeve
Quilted Side
• Insert a sleeve into the inside hole in the headboard.
• Position the cradle so that the quilted side is toward
the basin.
• While holding the cradle in place, insert a 1
with
1
/
" washer through the outside hole in the head-
2
board and into the cradle. Hand-tighten the screw.
Sleeve
Cradle
• While holding the cradle in place, insert a sleeve into
the outside hole in the foot of the cradle.
• Insert a 1
3
/
" screw with
4
hole in the foot of the cradle and into the basin. Hand-
tighten the screw.
Cradle
Basin
Basin
3
/
" screw
4
Basin
1
/
" washer through the inside
2
Assembly
Screw
Headboard
• Tighten the screw in the foot of the cradle and the head-
board with a Phillips screwdriver. Do not over-tighten.
• Check to be sure the cradle swings freely. If the cradle
does not swing freely, loosen the screw in the foot of
the cradle and the headboard
screwdriver. Again, check to be sure the cradle swings
freely, and loosen if necessary.
4
Screw
Foot of
Cradle
Cradle
Cradle
/
turn with a Phillips
1
4
Advertisement
