INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER
IMPORTANT NOTE TO INSTALLER:
IMPORTANT NOTE TO CONSUMER:
WARNING: If the information in this manual is not followed exactly, a fire or explosion
may result causing property damage, personal injury or death.
- Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
- Installation and service must be performed by a qualified installer, ser-
vice agency or the gas supplier.
NO ATTEMPT SHOULD BE MADE TO
OPERATE BUILT-IN OVEN DURING A
POWER FAILURE.
IMPORTANT
Remove all packing material and literature from the oven
and broiler compartments before connecting gas and
electrical supply.
A WIRING DIAGRAM FOR THIS
APPLIANCE IS ENCLOSED IN THE
ENVELOPE OVER THE APPLIANCE.
Printed in Canada
INSTALLATION INSTRUCTIONS
GAS BUILT-IN OVEN
BEFORE YOU BEGIN - READ THESE INSTRUCTIONS COM-
PLETELY AND CAREFULLY.
BE SURE TO LEAVE THESE INSTRUCTIONS WITH THE CON-
SUMER.
KEEP THESE INSTRUCTIONS WITH YOUR USE AND CARE
BOOK FOR FUTURE REFERENCE.
OBSERVE ALL GOVERNING CODES AND ORDINANCES.
SAVE THESE INSTRUCTIONS FOR LOCAL INSPECTORS.
IMPORTANT SAFETY INSTRUCTIONS
Installation of this appliance must conform with local codes, or in
absence of local codes, with the National Fuel Gas Code, ANSI
Z223.1 - latest edition.
This appliance has been design certified by the American Gas
Association. As with any appliance using gas and generating
heat, there are certain safety precautions you should follow.
You'll find them in your Use and Care book. Read it carefully.
• Be sure your appliance is installed properly by qualified installer
or service technician.
• This appliance must be electrically grounded in accordance
with local codes, or in their absence, with the National
Electrical Code ANSI/NFPA No. 70-latest edition. See Ground-
ing Instruction on page 3.
• The installation of appliances designed for manufactured
(mobile) home installation must conform with Manufactured
Home Construction and Safety Standard, Title 24CFR, Part
3280 [Formely the Federal Standard for Mobile Home Con-
struction and Safety, Title 24, HUD (Part 280)] or when such
standard is not applicable, the Standard for Manufactured
Home Installation 1982 (Manufactured Home Sites, Communi-
ties and Set-ups), ANSI Z225.1/NFPA 501A-latest edition, or
with local codes.
318064002 (9806) Rev. B