Tecnolux JC16CA20B Instruction Manual page 48

5.4. Operation mode
5.4.1. Cooling
• Press MODE (Fig.5.7) until "COOL" lights up.
• Press UP/DONW (Fig.5.4 & 5.6) to adjust the temperature which
is displayed on the screen. The temperature can be set between
16°C & 32°C. Afterward the display shows the room temperature.
• Press SPEED (Fig.5.3) until the LED of the desired speed lights
up.
Remark: The air conditioner stops if the room temperature
reaches the selected temperature. It starts again if the
temperature becomes higher.
5.4.2. Heating (optional – if installed on your appliance)
• Press MODE (Fig.5.7) until "HEAT" lights up.
• Press UP/DONW (Fig.5.4 & 5.6) to adjust the temperature which
is displayed on the screen. The temperature can be set between
16°C & 32°C. Afterward the display shows the room temperature.
• Press SPEED (Fig.5.3) until the LED of the desired speed lights
up.
Remark: The air conditioner stops if the room temperature
reaches the selected temperature. It starts again if the
temperature becomes lower.
5.4.3. Fan
• Press MODE (Fig.5.7) until "FAN" lights up.
• Press SPEED (Fig.5.3) until the LED of the desired speed lights
up.
5.4.4. Dehumidifying
• Press MODE (Fig.5.7) until "DRY" lights up.
• In this mode you can connect the drain hose for continuous
drainage, see Fig.13
• In this mode you can't adjust the speed.
5.4.5. Sleep mode
Press SLEEP (Fig.5.8) when the appliance is turned on in
cooling- or heating (optional) mode. In this mode the fan speed is
set at minimum and is not adjustable. You can turn off this mode
by pressing again on SLEEP.