Assembling / Installation - Tecnolux JC16CA20B Instruction Manual

4.

Assembling / Installation

4.1. Installation
Warning : before using the mobile air conditioning, keep it upright for
at least 48 hours.
The air conditioning can be easily moved in the room. In the moving
process, ensure that the air conditioning is in the upright position and
the air conditioning should be placed on a flat surface. Do not install
and use the air conditioning in the bathroom or other humid.
4.2. Install the heat pipe, see Fig.7
• Connect the hose connector to one end of the exhaust hose.
• Connect the window kit adapter to the other end of the exhaust hose.
• Connect now the hose connector to the appliance.
4.3. Install the window kit
• Half open the window, and mount the window sealing plate assembly
to the window, see Fig.8 & 9.
• Adjust the length of the window kit.
• Close the window as much as possible to fix the window kit.
Hint ! For optimal efficiency, we recommend that you buy
a thin insulation plate (in a DIY store) and cut it to fit your
window opening. Make sure it stays in place. Afterwards
place the oval side of connection piece (4) on the plate
and mark it. Now cut out the shape with a utility knife. Thanks to the
insulation plate you ensure an optimal seal and keep out the heat
4.4. Install the appliance
• Move the appliance with installed heat pipe and fittings before the
window, and the distance between the body and walls or other
objects shall be least 50 cm, see Fig.10.
• Adjust the length of the exhaust pipe and snap the flat end into the
window kit.
Remark: the pipe cannot be distorted nor has substantial turning
(greater than 45°).
Important: The length of the exhaust hose shall be 280~1,500mm,
and this length is based on the specifications of the air conditioning.
Do not use extension tubes or replace it with other different hoses, or
this may cause a malfunction. Exhaust host must be not blocked;
otherwise it may cause overheating.