Wireless Remote Control - LG W051CE SSF Owner's Manual

Temperature Control
5
The thermostat monitors room
temperature to maintain the desired
temperature. The thermostat can be set
between 16 °C–30 °C (60 °F–86 °F).
Press or
decrease temperature setting.
Remote Control Sensor
6
Clean Filter
7
The Clean Filter (Limpieza Filtro) LED
lights up to notify you that the filter needs
to be cleaned. After cleaning the filter,
press Temp
control panel to turn off the Clean Filter
(Limpieza Filtro) light.
NOTE
• The filter reset must be done using the
control panel, not the remote control.
• This feature is a reminder to clean the
air filter for more efficient operation.
The LED light turns on after 250 hours
of operation.
NOTE
• Auto Restart : If the air conditioner turns
off due to a power outage, it will restart
automatically once the power is restored, with
the same settings as were set before the unit
turned off.
• Energy Saver (Ahorro Energía) : The unit
defaults to the Energy Saver (Ahorro Energía)
mode each time the unit is switched on except
in Fan (Vent.) mode or when power is restored
after an electrical power outage.
• The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.
12
arrows to increase or
and together on the

Wireless Remote Control

Inserting Batteries
1
Push out the cover on the back of the remote
control with your thumb.
2
With the plus and minus poles facing as
marked, and insert two new AAA 1.5 V
batteries.
3
Reattach the cover.
NOTE
• Two new batteries are supplied with the air
conditioner for use in the remote control.
• Do not use a rechargeable battery. Make sure
that the battery is new.
• In order to prevent discharge, remove the
battery from the remote control if the air
conditioner is not going to be used for an
extended period of time.
• Keep the remote control away from extremely
hot or humid places.
• To maintain optimal operation of the remote
control, the remote sensor should not be
exposed to direct sunlight.
EN