DeWalt DWE6411 Manual page 21


WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.

WARNING: .
• Make sure all materials to be sanded are well secured.
• Apply only a gentle pressure to the workpiece.
Excessive pressure does not improve the sanding
effect, but only results in an increased load on the
machine and causes the abrasive to tear.
• Avoid overloading.
WARNING: Do not sand magnesium!
Proper Hand Position (Fig. IA, IB)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the main handle or
on the top of the unit as shown in Figures IA and IB.
Switching On and Off (Fig. A)
To switch the tool on, set the on/off switch
To switch the tool off, set the on/off switch to position O.
Sanding
1. Start with the coarsest grit size.
2. As the tool produces small scratch marks in all directions, it
is not necessary to sand with the grain.
3. Check your work at short intervals.
4. Always switch off the tool when work is finished and before
unplugging.
MAINTENANCE
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning


• After the tool is used in metal sanding applications without
dustbag, clean the tool using low-pressure air.
Optional Accessories

Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
1 to position I.
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
EngLIsh
WALT recommended
e
19