Chapter 4 - Active Mode Page 09 Appendix A - PIR Best Practices Page 10 Appendix B - Detection Distances Page 12 Appendix C - Technical Specifications Page 13 Appendix D - Contact Page 14 DocRef#0510601 IR-904 Extended Life - User Guide Page 1...
Chapter 1 - Hardware Hardware The IR-904 is housed in a small waterproof enclosure. IR-904 SENSOR BATTERY COMPARTMENT RED LED PROGRAMMING BUTTON RF TRANSMIT ANTENNA INFRARED DETECTION LENS DocRef#0510601 IR-904 Extended Life - User Guide Page 3...
Page 5
Sensor ID and Max Sensitivity. The also will illuminate when a range test or alarm is transmitted. After ten minutes into the Active Mode, the IR-904 will go into Covert Mode, and disable the LED.
Page 6
LENS. The beams are at a 15 degree angle. Both beams need to be DETECTION broken to detect a target. The IR-904 needs to be installed so that the INFRARED is not immediately blocked by any solid objects. (See Page 10 DETECTION LENS for more information on PIR Best Practices.)
After each programming menu, the IR-904 will play back the entered Sensor ID and Max Sensitivity. If the user does not program a Sensor ID or Max Sensitivity, the IR-904 will play back the default Sensor ID of 3, or the default Max Sensitivity of 5. Sensor ID Menu: The first menu is the Sensor ID menu.
Page 8
When the environment is stable again, the IR-903 will raise the sensitivity back up to the Max Sensitivity. (See Page 12 for more information on Detection Distances.) DocRef#0510601 IR-904 Extended Life - User Guide Page 7...
3 seconds. This Range Test will cause the receiver to briefly illuminate its LED to indicate that it is still in the range of the IR-904. This is very useful when choosing where to install the receiver. The Range Test Mode will last for 3 minutes. The...
Chameleon™ Environmental Adaptive Technology to adjust the sensitivity. When a target is detected, the IR-904 will transmit an Alarm. After an alarm transmission, the IR-904 will take up to 3.5 seconds to stabilize and return to the Active Mode. Covert Mode: After 10 minutes in the Active Mode, the IR-904 will disable the LED.
IR-904 field of view is solid ground. Solid ground would require the IR-904 to be angled down to the ground with no solid objects in the field of view. Lastly, the IR-904 can be aimed at solid walls or flat surfaces, but it is important to note that the two beams should be hitting the same material type.
Page 12
Similarly, a human target traveling at a very fast pace less than 5 feet from the IR-904 may not be detected. (See Page 12 for more information on Detection Distances.) Note: ●...
90+ days Sleep: <23uA Current RF Transmit: <115mA Domestic: 916.5MHz Radio Frequency International: 868.3MHz Transmit Power 100mW Dimensions 2.75” x 1.00” x 1.00” (7.0 x 2.5 x 2.5 cm) Weight 1.5oz (43g) DocRef#0510601 IR-904 Extended Life - User Guide Page 13...
Appendix D - Contact Appendix D: Contact Contact: IntelliCam LLC 11138 Air Park Road, Suite H Ashland, VA 23005 (+1) 804-798-1004 www.intellicam-llc.com DocRef#0510601 IR-904 Extended Life - User Guide Page 14...
Need help?
Do you have a question about the IR-904 and is the answer not in the manual?
Questions and answers