Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for IntelliCam MB-900
Summary of Contents for IntelliCam MB-900
- Page 1 MB-900 Motion Sensor DocRef # 0350602 MB-900 User Guide Revised 2019-06-18...
- Page 2 TABLE OF CONTENTS: Introduction Page 3 Controls and Indicators Page 3 Sensor Range Test Mode Page 4 Detection Mode Page 4 Sensor ID Programming Page 5 Sensor Sensitivity Programming Page 5 RF Interference Page 6 Contact Information Page 6...
- Page 3 The MB-900 has an integrated battery pack holding 2 each CR-1225 lithium batteries. Make sure to check for fully charged batteries and replace if necessary. PROGRAMMING BUTTON: The MB-900 has a programming button. This allows the user to abort Range Test Mode, program Sensor ID, or program a Sensor Sensitivity. RED LED: The RED LED is used for programming and as an alarm indicator.
- Page 4 RED LED will briefly illuminate and then go into a “Range Test” mode for approximately 2 minutes. Attach the MB-900 Sensor to the desired object. 2. Once in Range Test Mode, the sensor will begin transmitting at 1 second intervals.
- Page 5 1 second intervals. This is the “Range Test Mode”. Abort the Range Test Mode by briefly tapping on the Programming Button. In the Default Mode, the MB-900 Sensor is programmed for a Sensor ID of 1. You can change the ID by performing the following steps.
- Page 6 (if possible) prior to doing installation, or degraded reliability could result. WARNING: This device operates under Part 15 of the FCC Rules. Any modification not expressly approved by IntelliCam, LLC may void the warranty and the user’s authority to operate this device! CONTACT INFORMATION: IntelliCam LLC...
Need help?
Do you have a question about the MB-900 and is the answer not in the manual?
Questions and answers