Failure Display And Inspection - Lacor 69132 Instructions For Use And Maintenance Manual

If an abnormality comes up, the induction hotplate will enter the protective state automatically
and display corresponding protective codes:
Error Message
E0 Cause: No cookware or the cookware is not suitable for the induction cooker.
Solution: Put the suitable cookware on the cooking zone.
E1 Cause: The device becomes too hot (e.g. due to blocked ventilation slots)
Solution: Clear/unblock ventilation slots. Let the device cool off for a few minutes; the
Cause: Parts are damaged (e.g. transistor)
Solution: Contact retailer.
E2 Cause: Overheating-protection was activated and the device switched off.
Solution: Remove the cookware from the hob. Let the device cool off for a few
E3 Cause: Temporary overvoltage, device became too hot.
Solution: Let the device cool off for a few minutes. The devices is ready for
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the
induction hotplate.

FAILURE DISPLAY AND INSPECTION

device is ready for operation afterwards. Contact the retailer in case the
error message remains indicated in the display after the device has cooled
off.
minutes. The device is ready for operation afterwards.
operation afterwards.
26