Table of Contents
Advertisement
Hanging Mount
Tools required for assembly:
No. 2 Phillips screwdriver (not supplied)
10 mm wrench (not supplied)
NOTE: Hang the unit at least 7 Feet above floor level and
away from corners and any heating or cooling vents.
• Remove four screws from the cabinet top (Figure 5).
NOTE: Save the four screws for future use. These
screws will be needed to seal the holes in the cabinet
4
top if the eye bolts are removed.
Figure 5
Screw
• Thread a flange bolt almost all the way up onto each
eye bolt. (Figure 6)
• Thread the eye bolt into the hole on the cabinet top.
Tighten the eye bolt and flange nut against the top of
the cabinet.
• Repeat for remaining three eye bolts.
Figure 6
CAUTION
Mounting hooks must be anchored to a building
structure which can support a minimum of 100
pounds. Never mount to surface such as dry wall or
false ceiling grids, etc.
• Anchor the four chain, cable or steel strapping lines (not
supplied) into the buildings ceiling joist. Never mount to
surface such as dry wall or false ceiling grids, etc.
• Attach a chain (not supplied) to each hanging eye bolt.
NOTE: When the chains hang down freely they should
be 15-1/4" from left to right and 24-1/2" from front
to rear.
• With assistance raise and secure the air filtration system
eye bolts to the four hanging lines (Figure 7).
Figure 7
Eye Bolt
• Ensure the unit is level horizontally. Adjust if needed.
• Plug the power cord into the correct receptacle. (Refer
to Power Source paragraph in this section of the
manual.)
Flush Mounting
Mounting hardware must be anchored to a building
structure which can support a minimum of 100
pounds. Never mount to surface such as dry wall or
false ceiling grids, etc.
Eye Bolt
• Mark the air filtration system bolt pattern on the mounting
surface. NOTE: Bolt pattern should be 17-1/4" from left
to right and 31" from front to rear.
• Drill holes in the mounting surface at the marks.
Flange Nut
• Mounting bracket holes are found on each side of the
unit, slide the mounting brackets under the cover lip and
secure the mounting brackets to the unit with the 3 in 1
M6 Bolts (with flat washer and lock washer). Tighten all
bolts. (Figure 8)
• With assistance, carefully lift the air filtration system in
place aligning drilled holes to mounting brackets. Bolt the
air filtration system in place.
NOTE: Use 1/4" shank lag bolts for studs or 1⁄4" nuts,
bolts, and washers for mounting to supports.
Anchor
(not supplied)
Chain, Cable or
Steel Strapping
Lines
(not supplied)
CAUTION
Figure 8
Hex Bolt
Lock Washer
Flat Washer
Mounting
Brackets
Advertisement
Table of Contents
