Advertisement
.
3
INSTALL THE ANTI-TIP BRACKET
A
Fold or cut the front edge of the template, along the
front guide line. Place the template flush along the
front edge of the cutout floor, aligning the center
line of the template with the center line of the
cutout floor. Mark the center positions with an awl
or center punch for the anti-tip bracket location
as shown.
B
Remove the template and drill two holes for the
anti-tip bracket.
1
⁄
Screws (2)
2
C
Install the anti-tip bracket onto the cutout floor
using two
⁄
screws.
1
2
Installation Instructions
Cutout Floor
Anti-Tip Bracket
.
4
INSTALL SIDE DUCT AND
UPPER DUCT
A
Connect the side duct to the upper duct as shown.
1. Insert projecting tabs of the upper duct into the
holes of the side duct.
2. Bend the tabs up with caution as shown.
NOTE: Remove any oil or dirt on the surface of the
microwave oven before the ducts are attached.
Upper Duct
3 Holes
(1)
Side Duct
B
Set the microwave upright, being careful not to
bend the front flange. Remove the one existing
screw from the left side of the microwave oven.
C
Peel off the backing of the double sided tape.
Carefully position the side duct and upper duct
assembly on the microwave cabinet, aligning with
the bottom screw hole. Press down firmly on the
ducts. Fasten the duct assembly to the left side of
the cabinet with the screw removed above.
Existing Screw (1)
3
3 Tabs
(2)
Advertisement
