Advertisement
—— Instruction Manual ——
Drill In Floor Anchor For Use In Floating Wooden Floors
INSTALLATION OPTION USING EXPANDING CONCRETE ANCHORS
IMPORTANT NOTE:
1.
Pilot drill a 7/8" diameter hole through floor structure. Then use a 7/8" carbide tipped drill to extend the hole at least 2 9/16" into
the concrete.
2.
Open up hole in floor structure to 1 1/2" diameter, then route a hole 2 3/4" diameter by 3/8" deep at the top for the threaded
insert. Use caution so that the top of the insert is not below the floor level. If possible, route the hole at least 1/16" diameter
Date: 8/9/18
Rev: 5
VB25FL
B.A.
N.J.C.
File:\ I:\Publisher\Instructions\volleyball
1
Customer Service
(800) 247-7668
Ref#: 960971
Advertisement
Table of Contents
Related Manuals for Bison VB25FL
Summary of Contents for Bison VB25FL
- Page 1 —— Instruction Manual —— VB25FL Drill In Floor Anchor For Use In Floating Wooden Floors Customer Service (800) 247-7668 INSTALLATION OPTION USING EXPANDING CONCRETE ANCHORS IMPORTANT NOTE: Pilot drill a 7/8” diameter hole through floor structure. Then use a 7/8” carbide tipped drill to extend the hole at least 2 9/16” into the concrete.
- Page 2 INSTALLATION OPTION USING GROUTED METHOD IMPORTANT NOTE: Bore 1 1/2” diameter hole through the floor and concrete using a carbide tipped drill bit to a depth of 6” maximum. Route a 2 3/4” diameter by 3/8” deep at the top for the threaded insert. Use caution so that the top of the insert is not below the floor level.
- Page 3 Volleyball Court Diagram...
Need help?
Do you have a question about the VB25FL and is the answer not in the manual?
Questions and answers