Incredible Technologies PANEL J203 Setup Manual

1
Mounting and Installation
Mount the Main Screen Display
Position the Showpiece cabinet in front of the ideal HDTV location.
The HDTV is intended for use with the Showpiece Integrated Stand
(Model 304S) but can also be mounted to a wall. Be sure that the top
of the Showpiece cabinet has at least 24" clearance in all directions.
Insufficient clearance may result in damage to your display or player
injury.
The recommended height for your display may vary depending
on your location and player base. As a general rule, the
minimum height of the bottom of the display viewing area
should be 42" from the floor.
Leg Leveler Adjustment
The leg levelers help stabilize the game on an uneven floor, and help it from moving or shifting during game play. The
game is shipped with the two front and two rear leg levelers installed. Adjust the levelers as necessary to level and stabilize
the game.
Connect USB Cables
The USB cables from the Nighthawk system box to the Cabinet Identification Device (CID) and I/O Board ship
disconnected. To connect them, unlock and lift open the player control panel to access the cables and electronics. The two
cables and boards are on the left side. (The USB cables are identical and interchangeable.) Use the Cable Connection
Diagram on the reverse side of this guide for reference.
Install the Marquee
The Showpiece cabinet comes with a framed marquee header that can be easily attached to the top of your HDTV. The
brackets for the header are shipped inside a separate cardboard insert labeled Parts – Do Not Discard within the cabinet
packaging. The insert is located on the top of the
control panel.
First, attach the two brackets to the back of the
universal mounting plate you are using for your
HD display. The brackets share the same screws
used to affix the display to the mounting plate,
and are sandwiched between the plate and the
back of the HDTV. Once the brackets are in
place, slide the marquee frame onto the clips on
the two newly mounted brackets. Be sure the tab
on the clips rests inside the channel on the
marquee frame.
©2015 Incredible Technologies, Inc. All Rights Reserved. Non-IT trademarks are the properties of their owners and used for illustration only. Unauthorized duplication or disclosure may violate applicable laws or agreements.
SHOWPIECE CABINET
2
Audio/Video Connections
Connect HDMI Cable to HDTV
Connect the HDMI cable (supplied) to the HDMI output
on the Nighthawk system box. Route the cable through
the clip under the lock on the back wall, and down
through the access panel on the back of the cabinet.
(The access panel needs to be removed and replaced.)
Connect the other end of the HDMI cable to a HDMI
input on your HDTV. The HDMI cable also supplies
audio to the speakers on your HDTV.
IT games do not support medium and low
resolution monitors. GT LIVE has a default
resolution setting of 1080p. All other games are
set for 720p. See Resolution Settings on the
reverse side for reference.
Set Up HDTV
Refer to the HDTV manual to select the
correct video input signal for your game.
Selecting the correct input is commonly
found from a system menu accessed from
the remote, or an Input Select button on the
HDTV.
Connect the cabinet AC power cord to a wall
outlet and turn on the cabinet power switch.
See reverse side for Connections and Settings information.
This Setup Guide is one of two guides IT uses to help operators better understand our Showpiece cabinets. For more detailed
installation instructions, visit
your game. The Manual & User Guide includes a guide to the in-game menus and detailed instructions for Kit assembly.
If your Showpiece cabinet needs repair, or you have a technical question, call (847) 870-7027 x380 between 7 a.m. and 6
p.m. CST Monday through Friday, or email support@itsgames.com.
Nighthawk System Box
http://amusement.itsgames.com/service/manuals and download the Manual & User Guide for
Setup Guide