Table of Contents
Advertisement
Quick Links
L5 Document Camera Drawer
THANK YOU
Thank you for purchasing the L5-DCD23 document camera drawer.
Please read these instructions thoroughly before installing or assembling this product.
PRODUCT FEATURES
L5-DCD23
• 23.5" Depth X 21" Width
• Left or right frame installation to align with wood kit.
• Weight capacity 50 lbs.
Instruction Sheet
L5-DCD23
I-00816
Rev A
Advertisement
Table of Contents
Related Manuals for Middle Atlantic Products L5-DCD23
Summary of Contents for Middle Atlantic Products L5-DCD23
- Page 1 Instruction Sheet L5-DCD23 L5 Document Camera Drawer THANK YOU Thank you for purchasing the L5-DCD23 document camera drawer. Please read these instructions thoroughly before installing or assembling this product. PRODUCT FEATURES L5-DCD23 • 23.5” Depth X 21” Width • Left or right frame installation to align with wood kit.
-
Page 2: Weight Ratings
AVERTISSEMENT: Ne pas utiliser un produit endommagé. Retour produits endommagés à un centre de service qualifié pour la réparation. WARNING: Not intended for outdoor use. AVERTISSEMENT: Non destiné à une utilisation en extérieur. WEIGHT RATINGS Model Weight Rating L5-DCD23 50 lbs. Maximum Total Rated Load Page 2... -
Page 3: Required Tools
REQUIRED TOOLS • #2 Phillips Screwdriver • 3/8” Nut Driver and Handle (Supplied) WARNING: Use tools with caution and follow all necessary safety protocols. AVERTISSEMENT: Utiliser des outils avec prudence et suivre tous les protocoles de sécurité nécessaires. SUPPLIED COMPONENTS Left &... - Page 4 DRAWER INSTALLATION OPTIONS NOTE: For 33” and 43” frames, document camera drawer can be installed into left or right side of L5 frame to align with wood kit. Camera drawer can NOT be installed on 23” models. (FIGURE A) (4x) slide mounting holes for (4x) slide mounting holes for camera shelf installed on camera shelf installed on...
- Page 5 MAGNETIC STOP INSTALLATION 1. Slide clip nut (G) over hole in frame. (FIGURE B) 2. Place magnetic stop bracket (E) over clip nut. (FIGURE B) 3. Tighten magnetic stop bracket (E) to frame using 10-32 x 3/4” truss head screw (F). (FIGURE B) 4.
- Page 6 DRAWER SLIDE INSTALLATION 1. Install the slides (B) into the mounting holes and secure in place using (4x) hex nuts (D) on each side of frame. (FIGURE C) 2. Tighten down using supplied nut driver and handle (C). NOTE: Slide stop bumpers must face inside frame when installed.
-
Page 7: Drawer Installation
DRAWER INSTALLATION 1. To install camera drawer (A), fully extend both slides. Align slides and push drawer onto slides until they click into place. (FIGURE D) 2. Drawer is equipped with an open position lock. To close drawer, depress both lock levers at the same time while pushing the drawer closed. -
Page 8: Warranty
Voice: 613-836-2501 - Fax: 613-836-2690 / ca.middleatlantic.com - customerservicecanada@middleatlantic.ca Factory Distribution USA: NJ - CA - IL Canada: ON - BC At Middle Atlantic Products we are always listening. Your comments are welcome. Middle Atlantic Products is an ISO 9001 and ISO 14001 Registered Company. Page 8...