Parts & Accessories; Service Parts & Accessories; Bulb Replacement; Headlamps - Caterham SEVEN Owner's Handbook Manual

Parts & Accessories
Service parts & accessories
Only Caterham Cars and their approved dealers
are able to provide the full range of recommended
parts and accessories which meet our rigorous
standards of safety, durability and performance.
To ensure your future driving pleasure and safety,
we strongly recommend that only Caterham
approved parts are fitted to your car.
All genuine Caterham parts and accessories are
guaranteed for twelve months or 6000 miles
(whichever is sooner).
A comprehensive parts resource is available from
Caterham Aftersales or via our online store at
www.caterhamcars.com
Fitment of non-Caterham approved parts may
affect the resale value of your car.
WARNING!

It is extremely hazardous to fit parts or
accessories where installation requires the
dismantling of, or addition to, either the
electrical or fuel systems.

Fitting parts or accessories that have not
been approved by Caterham, or the carrying
out of non-approved
conversions, may be dangerous and could
affect the safety of the car and occupants,
and also invalidate the terms and conditions
of the car's warranty.

Bulb Replacement

Table 8: Bulb replacement part numbers from
Caterham
Light Unit
Headlamp (halogen)
Sidelamp
Front/Rear Indicator
Tail/Stop
Rear Fog
Side Repeater Indicator
Reversing
Rear Number Plate (x2)
alterations or
Caterham Part
Wattage
Number
60/55 BB472
5 LLB501
21 LLB382
21/5 LLB380
21 LLB382
4 LLB233
21 LLB382
4 LLB233

Headlamps

Loosen the screw on top of the headlamp bowl until
the rim with the light attached can be unclipped and
pulled free. The wiring is released from the back of
the lamp unit by pulling off the plastic connection.
The bulbs can be changed by removing the rubber
dust cover then squeezing the retaining clip to
release the bulb itself. Care should be taken not to
touch the Halogen bulb glass as this may cause it
to blow on first use.

Side lamp (front)

First release headlamps as above. Sidelamps are
connected separately into the back of the headlamp
and pull free to enable bulb changing. The side
lamp bulb is a capless bulb and can be removed by
pulling it straight out of its holder.

Indicators (front)

Remove the two screws holding the lens in place.
The bulb can then be removed and the new one
refitted by pushing and turning through 45°.

Indicator repeaters (front)

Remove the single screw holding the lens and
unclip. The bulb can then be removed and the new
one refitted by pushing and turning through 45°.

Stop/tail and indicators (rear)

The lenses are held in place by two screws which
allow the complete lens to be removed for access.
The bulbs can then be removed and the new ones
refitted by pushing and turning through 45°.

Rear fog light, reversing light

The lenses are held in place by two screws which
allow the lens to be removed for access. The bulbs
can then be removed and the new ones refitted by
pushing and turning through 45°. When refitting the
lens ensure that the rubber seal is fitted correctly to
prevent water ingress.

Number plate lamp

The number plate lamp contains two bulbs which
can be removed and refitted by pushing and turning
through 45°. To gain access to the bulbs the black
cover must be removed, this is held in place by a
single screw in the centre of the cover.
47