Advertisement
4.4
Fitting the Legs:
Insert the legs into the side frame assemblies and
secure with 4 x E-clips.
Make sure that all legs have been adjusted
to the same height.
4.5
Fitting the Padded Seat:
Fit the padded seat to the seat frame assembly.
Make sure the commode is fully secure
before use.
4.6
Fitting the Optional Lap Strap (N99091)
B
To fi t the lap-strap, feed the two rear buckles (B)
through the slots in the seat.
The buckles (B) must be pushed fully through the
slots, by rotating them through 90 degrees.
Pull the straps from the front to locate the buckles
(B) as shown. Make sure the buckles cannot pull
through the seat, by tugging fi rmly.
4.7
Fitting the Commode Pan:
Slide the commode pan into the rails on the seat
assembly.
The commode pan is held in place by
retainer pins, pull forward to release.
5.
ADJUSTING THE COMMODE
5.1
Adjusting the Height:
Remove the 4 x E-clips and adjust the legs to the
desired height.
Replace the 4 x E-clips.
Make sure that all legs have been adjusted
to the same height.
3
B
Advertisement
