Turn On Your Digitsole Connected Insoles; Charging The Insoles; Adjusting The Soles - Digitsole WARM Series User Manual

Turn on your Digitsole connected insoles

Charging the insoles

To charge your insoles:
1. Connect the charging cable to a USB power
supply (preferred) or to the USB port on your
computer. Use only the number of cables
that came
2. Then connect your insoles to the 2 micro-
USB
A full charge takes about two and a half hours. Once charged, the insoles can last up to 8 hours. The
battery discharge time varies according to the use: heating set point, type of shoes worn...
NOTE: The insoles are programmed to go into "sleep mode" if not connected to a phone when no
movement is detected for five minutes. This mode is designed to save battery power when the insoles
are not in use.
Charging and connecting your insoles
The insoles must be fully charged before first use.
•
To charge, open the protective cap on each insole.
•
Insert the two micro-USB connectors of the supplied cable into the insoles.
•
Connect the remaining single USB portion to a computer or wall outlet.
•
When charging, the LED on the module is red, it will automatically turn off when the battery is
100% charged.
To check the LEDs in an optimal way, we advise you to place yourself in a dark place to observe them.

Adjusting the soles

To adjust the size of the soles to your shoes, you can cut them along the lines.
Be careful not to cut beyond the dotted lines on the bottom of the soles, as this could damage the
electrical components and the soles may not heat up. Also, the warranty would be void.
with the device.