Table of Contents
Advertisement
Installation Cont.
Electrical connection
• WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
• Before plugging in your new fridge, let it stand upright for at least half an hour. This will allow the
refrigerant gases to settle into the compressor and reduce the possibility of a malfunction in the
cooling system.
• The appliance must be earthed. The plug of the power supply cord is equipped with a contact for
this purpose. Do not under any circumstances cut or remove the third (earth) prong from the power
cord. If the plug does not fit your outlet, consult a licensed electrician for advice to have the outlet
changed.
• Plug the unit into a dedicated, properly earthed wall outlet. Ensure that your outlet voltage and
circuit frequency correspond to the voltage stated on the rating label.
• Secure the fridge's supply cord behind the unit. Do not leave it exposed or dangling to prevent injury
and accidental disconnection from the power supply.
• Adjust the temperature control as described below.
• When first starting up, and after a period out of use, allow the unit to cool down for at least
2–3 hours(4 hours if starting up during warm weather in summer) before placing food in the fridge.
IMPORTANT: Once the unit has started, continuous operation is recommended. Please try and avoid
turning the unit off and on as this may affect the service life.
Changing the Light
Any replacement or maintenance of the LED lamps is intended to be made by the manufacturer, its
service agent or similar qualified person.
Replacement of incandescent lamps:
• Disconnect the power supply before carrying out the bulb replacement.
• Hold and remove the light bulb cover.
• Dismantle the old bulb by unscrewing it counterclockwise and replace with a new bulb (Max. 15W)
by screwing it in clockwise, and make sure it is fixed in the bulb holder tightly.
• Reassemble the light cover and re-connect your Chest Fridge/ Freezer to the power supply.
11
Advertisement
Table of Contents
