Glasdon RETRIEVER 50 Fitting Instructions

RETRIEVER 50™
Post and 'Ground- Lock' Fixing System
IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THE POINTS LISTED BELOW AND THAT A
When selecting a site, ensure there are no buried services.
Parts list
1 ) Bin and Key
2 ) Post for Ground-Lock version
3 ) M6 x 12mm Stainless Steel Security screw
4 ) M10 x 30 slotted panhead screw
5 ) M10 Lock washer
6 ) Security Allen key
7 ) Ground-Lock socket
8 ) M10 x 70mm Bolt
9 ) M10 metal Washer
10) Socket Block
11) * Installation cap
12) * Insertion tool
*Supplied separately by Glasdon
Stage one
Remove the safety tube from the end of the 'Ground-Lock'
leaving the BURIED SERVICES STICKER in place.
Push the Ground-Lock ( 7 ) socket spike into the chosen
ground in a vertical position until it stands alone, ensuring
that when bin and post are finally fitted the correct
orientation is achieved.
Position the installation cap ( 11 ) See Diagram 1.
Note:- If the ground conditions are hard, a two man
operation may be required to achieve a satisfactory
installation.
Hammer the 'Ground-Lock' into the ground with even
strokes until the horizontal bracket (affixed to the top of the
'Ground-Lock') is level with the ground.
When half way into the ground check the vertical position
and adjust if necessary then continue installation until the
top of the 'Ground-Lock' is at ground level.
Remove and retain the installation cap ( 11 ) for further use.
Stage two
Take the socket block ( 10 ) and screw onto the end of the
insertion tool ( 12 )
Ensure that the socket block is screwed hand tight only to
the threaded end section. See Diagram 2.
Fitting Instructions
COPY IS GIVEN TO THE STAFF INVOLVED WITH THE INSTALLATION
Equipment Needed for Installation (not included)
17mm Socket spanner
x1
Socket Wrench
x1
x2 15mm Spanner
x2 Flat Headed Screwdriver
Safety Shoes
x2
Sledge Hammer
x1
x1 Suitable Gloves
x1 Ear-Defenders
Spade or Trowel
x1
x1
x1
x1
Diagram 1
.
11
7
Diagram
10
2
12