Cutting Unit Attitude - Toro Reelmaster 2000 Series Operator's Manual

3. Place the gauge bar across the front and rear rollers.
The first screw head needs to fit snugly over the edge
of the bedknife while the gauge bar contacts the rollers
(Fig. 14).
Figure 14
1. First screw
2. Second screw
3
2
1
3. Gauge bar angle
11
4. Adjust the second screw to contact the bedknife.
5. Place an angle indicator on the gauge bar and record
the gauge bar angle (Fig. 14).
6. Bedknife Angle (step 1) – Gauge Bar Angle (step 5) =
Cutting Unit Attitude (degrees)
7. For adjusting the cutting unit attitude, adjust the rollers
to achieve desired cutting unit attitude.
Important
Make sure rollers are parallel to reel,
repeat leveling procedure, if necessary.
Note: If rollers are parallel to reel before changing
bedknife attitude, you can change one roller at a time and
still maintain parallelism.