Brickstuff TREE01 Instructions For Use

Welcome, and Thank You!
Thank you for purchasing this Brickstuff product. We hope you enjoy using it as much as we en-
joyed creating it. The parts in this box are only part of our story, only part of what we're working
hard to develop. Our goal is to create the most flexible and exciting line of hobby lighting and
automation products for you to use in all of your fantastic creations. All of these products will
work together, and you won't need to be an electronics expert to use them. So keep building
amazing things—we'll help you bring them to life.
Thanks again for supporting us. We couldn't do this without you!
2-LED Light Strip Starter Kit
INSTRUCTIONS FOR USE
Carefully remove all parts from the included re-sealable anti-static bag:
Nine 2-light LED strips with adhesive backing

Eleven black connecting cables

Three adapter boards

LEGO® plates for mounting in a LEGO® creation

Depending on the specific kit purchased, there may also be a power supply in the box, or you may
have purchased a kit without a power supply.
DECIDE:
How will you be using the light strips? If you will be
using the adhesive backing to mount the strips, make
sure you have all parts collected and ready before
peeling the adhesive. When using the self-adhesive
backing to mount light strips, try to mount in a perma-
nent configuration (where the light strip won't be re-
moved and re-attached multiple times). If mounting
in a LEGO® model, mount the light strip to a 1x6 plate
(included) and then move the plate, not the light strip,
if necessary to reposition.
CONNECT:
Connect the strips end-to-end using the included black cables. Be careful when disconnecting
light strips not to pull using the cable (this will damage the cable)—disconnect the light strip by
holding the cable connector firmly and pulling. You can use the included 1x2 black LEGO® plates
to hold slack in connecting cables by winding extra cable around the black plates, then snapping
the black plates onto a ceiling in a building.
When mounting the light strips, mount in such a manner as to remove stress from the connecting
cables at the point they plug into the light strip. This will prevent cables pulling out over time.
WARNING: This product contains small parts and sharp parts. This product is
not a toy. It is not intended for children under 13 years of age.
--- The Brickstuff Team
info@brickstuff.com
Attaching Light Strip to a 1x6 LEGO Plate
for easy repositioning.