Thank you for purchasing this Brickstuff product. We hope you enjoy using it as much as we enjoyed creating it. The
parts in this box are only part of our story, only part of what we're working hard to develop. Our goal is to create the
most flexible and exciting line of hobby lighting and automation products for you to use in all of your fantastic creations.
All of these products will work together, and you won't need to be an electronics expert to use them. So keep building
amazing things—we'll help you bring them to life.
Thanks again for supporting us. We couldn't do this without you!
#75827 Firehouse HQ Lighting Kit
This kit includes multiple lighting assemblies and other parts needed to light up your Firehouse Headquarters. The parts
are supplied in four different bags: three bags specific to each floor in the headquarters, and one bag with six ceiling lights
(used on multiple floors). Remove all bags from the box, and begin installing your lights starting with the first floor (bag
1). The following diagram shows how to install the lights and adapters on the first floor:
Mount both front lights, care-
fully running the wires up the
wall and between bricks.
Mount three ceiling lights, and coil the wires
around the middle assembly.
Run the 6" black cable from
the leftmost connector on
the 9-port adapter, be-
tween the studs and out
the back of the top wall.
Cover wire with dark gray
tiles.
All lights should be con-
nected to the 9-port adapt-
er, with the exception of
the slime LED and the
alarm bell light. These
should be connected to the
effect controller. Connect
the effect controller to the
rightmost plug on the 9-
port adapter using the
black 1.5" cable.
Welcome, and Thank You!
INSTRUCTIONS FOR USE
Run the front light wires between studs— DO NOT PINCH
WIRES ON TOP OF STUDS. Carefully re-attach dark gray
tiles to secure wires in place.
Using the included sticky squares, mount the 9-port
adapter along the top of the wall, replace the alarm bell
light and connect it to the lighting effect controller,
mount the table lamp, mount the desk lamp, and mount
the slime LED (outside the building). Run all wires inside
and up the wall. Connect lights to the 9-port adapter.
--- The Brickstuff Team
info@brickstuff.com