KWM Gutterman PANTHER Operating And Maintenance page 32

This section is only a brief summary. Please read the entire manual prior to operating
machine.
The order of operation.
1. Connect the machine to a 110v power source using the proper extension cord.
(see pg. 4) Position drum switch to forward position.
2. Remove spool retaining pin from the spool you have elected to run.
3. Trim both corners of the coil at a 45 degree angle approximately 3" in from edges.
Insert trimmed coil into the entrance guide system making sure coil is snug to both
sides,with free front to back movement, push coil to the #1 drive station.
4. The drum switch can be used for forward and reverse operation of the machine once
machine is fed. Run gutter to desired length and cut off using guillotine. Run-out
support stands must be used to support gutter after 8'.
5. Prior to the completion of the last piece being produced, cut the coil stock before the
entrance guides. Feed machine with the next job color prior to transportation of the
machine. (NEVER TRANSPORT MACHINE WITHOUT COIL FED THROUGH ALL
STATIONS.)
SECTION 15
Machine operation recap and summary.
Straight Blade Guilotine
– 30 –