Attach The Monitors - NEC CHIEF K3F220 Installation Manual

5. Adjust the tilt-angle of the VESA plate parallel to the
arm surface Do not rotate the plate
6. Tighten the hex screw
finished setting the position of the VESA plate.

Attach the Monitors

Two people will be needed to attach the monitors to the stand
1. EX241UN-H (no stand) – Remove the lower 2
screws from the back of the monitor Loosen the
upper 2 screws to have some space between the
screw-head and back casing
EX241UN (with stand) – Have 4 VESA M4 standard
screws available, then set the lower 2 screws with
some space between the screw-head and back
casing
2. With one person holding the monitor from the front
and one person holding the monitor from the back,
carefully hang the monitor on the VESA plate of the
arm
Repeat this for the second monitor
Ⓒ Ⓓ
and knob when
2 x 2 mUlti-monitoR installation (K3F220/K3g220) | 10
Ⓓ
CHIEF STAND INSTALLATION MANUAL | USER'S GUIDE
Ⓒ