Important Safety Instructions - HYPERICE Vyper Go Operating Instructions Manual

Hide thumbs Also See for Vyper Go:
Table of Contents

Advertisement

Available languages

Available languages

EN
TO REDUCE RISKS OF ELECTRIC SHOCK, FIRE, AND PERSONAL
INJURY, OR PROPERTY DAMAGE, THIS DEVICE MUST BE USED IN
ACCORDANCE WITH THE FOLLOWING WARNINGS, CAUTIONS, AND
SAFETY INSTRUCTIONS.
IMPORTANT SAFETY
INSTRUCTIONS -
ORIGINAL INSTRUCTIONS
Read all instructions before using the Vyper Go.
DANGER
To reduce the risk of electric shock:
• Always unplug this device from the electrical outlet immediately after using and
before cleaning.
• Do not reach for a device that has fallen into water. Unplug immediately.
• Do not use while bathing or in a shower.
• Do not place or store device where it can fall or be pulled into a tub or sink. Do not
place in or drop into water or other liquid.
WARNING
To reduce the risk of burns, fire, electric shock, or injury to persons:
• A device should never be left unattended when plugged in. Unplug from outlet when
not in use, and before putting on or taking off parts.
• Do not operate under blanket or pillow. Excessive heating can occur and cause fire,
electric shock, or injury to persons.
• Use this device only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
• Never operate this device if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or if it has gotten wet. Return the
device to a service center for examination and repair.
• Do not carry this device by supply cord or use cord as a handle.
• Keep the cord away from heated surfaces.
• Never operate the device with the air openings blocked. Keep the air openings free
of lint, hair, and any substance which may impair the flow of air.
• Never drop or insert any object into any device opening.
• Do not use outdoors.
• Do not operate where aerosol (spray) devices are being used or where oxygen is
being administered.
• Never operate on a soft surface where the air openings may be blocked.
• Do not remove screws or attempt to disassemble.
• Unplug the device after charging or prior to use.
• Use device only according to these Operating Instructions, also available on
hyperice.com.
• Do not operate continuously for more than one hour. After one hour use, allow unit
to rest for 30 minutes before re-using.
• Unplug the unit after charging or prior to use.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Vyper Go and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

31020 001-00

Table of Contents