Advertisement
MLS Digital Mid-Bay & Hi-Bay Luminaire Controllers
Only suitably qualified personnel should install this equipment.
Electrical Connections
32.5mm
Mounting Details
C L
Installation
Snap-in to infill panel (max 0.7mm/ 22 SWG) or use any combination of fixing holes on rear. Use only No 4
type B ¼ inch self-tapping screws. Ensure that projection of screws into pilot holes does not exceed 4.5mm.
The recommended position for the detector is in the middle of the luminaire. Where this is not possible and the
detector is fitted near one end of the lamps, please ensure that the detector is at the 'cold' end of the lamps.
In order to achieve satisfactory light-level regulating operation, a detector must observe a substantially greater
proportion of artificial light from the luminaire(s) under its control than from neighbouring luminaires not under its
control. This is particularly important when planning the installed layout of linear luminaires that have an
integral detector positioned at one end.
To Test Luminaire Controller Operation
Once the Luminaire Controllers have been installed within the luminaires, the HC5 or HC6 may be used to
switch luminaires ON and OFF. Luminaires with regulating ballasts will also dim and brighten.
750mm
lead
43.5mm sq
50mm sq
C L
Red
- Live
Blue
- Neutral
Yellow
Polarity-free
Green
digital output
White - MLS Bus +ve
Black - MLS Bus -ve
26mm
6.5mm
Cable entry point
Connection to ballast only.
Do not connect to other detectors.
Advertisement
